Renault Clio: Rear view mirrors
Door mirrors with electrical adjustment
With the ignition on, turn button 1:
- position C to adjust the left-hand door mirror;
- position E to adjust the right-hand door mirror;
D is the inactive position.
| For safety reasons, carry out any adjustments when the vehicle is not being driven. |
Heated door mirrors
With the engine running, mirror deicing is activated simultaneously with rear screen de-icing/demisting.
Folding door mirrors (depending on vehicle)
Move button 1 to position F: the door mirrors fold away. To reset them for driving, return to position C, D or E.
If you manually fold the door mirrors, before setting them to the driving position (C, D, E), you must position control 1 to F
| The driver’s door mirror
may have two clearly defined
zones. Zone B shows
what can normally be seen
in an ordinary rear view mirror. Zone A increases rear side visibility. Objects in zone A look much further away than they really are. |
Interior rear view mirror
Its position can be adjusted.
Rear-view mirror with lever 2
For night driving, to avoid being dazzled by the headlights of the car behind you, flip the small lever 2 located behind the rear view mirror.
Rear view mirror without lever 2
The rear view mirror darkens automatically at night if you are being followed by a vehicle with its lights on.
READ NEXT:
Exterior lighting and signals
Side lights
Turn the ring 2 until the symbol
is opposite mark 3.
An indicator light on the instrument
panel will come on.
Daytime running lights function
(front lights only)
Dependin
Audible and visual signals
Horn
Press steering wheel boss A.
Headlight flasher
Pull stalk 1 towards you to flash the
headlights.
Direction indicators
Move stalk 1 parallel to the steering
wheel and in the direction y
Headlight adjustment
On vehicles fitted with this function,
control A allows you to adjust the height
of the beams according to the load.
Turn control A downwards to lower the
headlights and upwards to raise the
SEE MORE:
Solenoid valve assembly pressure sensor: Removal - Refitting
K9K, and JA5
REMOVAL
REMOVAL PREPARATION OPERATION
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Discharge pressure accumulator " AC081.
To confirm the pressure drop, read the " Hydrauli
Rear inner sill upper trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Partially remove seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the trim at (2) and at (3).
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
Refit the rear door sill upper trim.
II - F
