Renault Clio: To the rear seat belts
Force limiter
Above a certain severity of impact, this
mechanism is used to limit the force of
the belt against the body so that it is at
an acceptable level.
- Have the entire restraint
system checked following
an accident.
- No operation whatsoever
is permitted on any part of the
system (air bags, electronic control
units, wiring) and the system
components must not be reused
on any other vehicle, even if identical.
- Only qualified personnel from
our Network may work on the air
bags; otherwise the system may
trigger accidentally and cause
injury.
|
READ NEXT:
Side Airbags
This airbag may be fitted to each of the
front seats and is activated at the sides
of the seats (door side) to protect the
occupants in the event of a severe side
impact.
Dep
All of the warnings below are given so that the airbag is not obstructed in
any way when it is inflated and also to prevent
the risk of serious injuries caused by items which may be dislodged when
SEE MORE:
1/3 and 2/3 rear bench seat base trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lift up the rear bench seat base.
Remove the rear bench seat base at (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the retaining strips (2).
Remove the seat trim and foam.
DOCUMENTATION PHASE 1
REMOVAL
DISCHARGE LAMPS
IMPORTANT
To prevent eye injuries:
do not look at a xenon bulb when lit (voltage
when lit 20000 V),
do not light a bulb which has not been fitted into
its headlight.
IMPORTANT
To prevent burns, wait until the " computers -
power unit " assemblies a
© 2016-2024 Copyright Renault Clio Owners Club