Renault Clio: Trip computer and warning system

Information messages

These can help in the vehicle starting phase, or give information about a selection or a driving status.

Examples of information messages are given in the following pages.

Examples of messages

Interpreting the display selected

« PARKING BRAKE ON » Indicates that the parking brake has been applied
« PLEASE REMOVE KEYCARD » Request to remove the RENAULT card from the reader when you leave the vehicle.
« TRACTION CONTROL OFF » Indicates that you have deactivated the traction control function.
« TURN STEERINGWHEEL + START » Turn the steering wheel slightly whilst pressing the vehicle start button to unlock the steering column.
« STEERING WHEEL NOT LOCKED » Indicates that the steering column has not been locked.

Operating fault messages

These appear with the warning
light and mean that you should drive very carefully to an authorised dealer as soon as possible. If you fail to follow this recommendation, you risk damaging your vehicle.

They disappear when the display selection key is pressed or after several seconds and are stored in the computer log. The warning light stays on. Examples of
operating fault messages are given in the following pages.

Examples of messages

Interpreting the display selected

« CLEAN DIESEL FILTER » Indicates the presence of water in the diesel filter; contact an approved Dealer as soon as possible.
« CHECK VEHICLE » Indicates a fault in one of the pedal sensors, battery management system or oil level sensor.
« CHECK AIRBAG » Indicates a fault in the restraint system in addition to the seat belts. In the event of an accident, it is possible that they may not be triggered.
« CHECK ANTI-POLLUTION SYSTEM » Indicates a fault in the vehicle’s particle filter system.

Warning message

These appear with the warning
light and require you to stop immediately, for your own safety, as soon as traffic conditions allow. Stop your engine and do not restart it. Contact an approved Dealer.

Examples of warning messages are given in the following pages. Note: the messages appear on the display either individually or alternately (when there are several messages to be displayed), and may be accompanied by a warning light and/or a beep.

Examples of messages

Interpreting the display selected

« ENGINE FAILURE HAZARD » Indicates an injection fault, the vehicle’s engine has overheated or there is a serious engine fault.
« BRAKING SYSTEM FAULT » Indicates a fault in the braking system.
« BATTERY CHARGING FAULT » Indicates a fault in the vehicle battery charging circuit (alternator etc.).
« PUNCTURE » Indicates that at least one wheel is punctured or severely underinflated.

READ NEXT:

 Clock and exterior temperature

 Display A

To access display 1 for setting the time, press button 2 or 3. Wait for a few seconds. The hours and minutes flash and you are now in setting mode; press and hold button 2 or 3 to set the ho

 Display B

Vehicles fitted with touch-screen multimedia, navigation aid systems, telephones, etc. Refer to the separate instructions for the function to understand the special features of this equipme

SEE MORE:

 Front side member, centre section: General description

IMPORTANT Use a repair bench to ensure the positioning of the points and the geometry of the axle assemblies. Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for this part. Before reading the following general informati

 RENAULT card: battery

Replacing the battery When the message “KEYCARD BATTERY LOW” appears on the instrument panel, replace the RENAULT card battery, press button 1 pulling on emergency key 2, then unclip the cover 3 using tab 4. Remove the battery by pressing on one side (movement A) and by lifting the

© 2016-2024 Copyright Renault Clio Owners Club