With the engine running, when the needle is:
- in zone A , the temperature is correct, - in zone B, the temperature is too high; the maximum temperature and the central STOP warning lamps come on, accompanied by an audible signal and a warning message in the screen.
You MUST stop as soon as it is safe to do so.
Wait a few minutes before switching off the engine.
Contact a PEUGEOT dealer or a qualified workshop.
After driving for a few minutes, the temperature and pressure in the cooling system increase.
To top up the level:
wait for the engine to cool, unscrew the cap slightly to allow the pressure to drop, when the pressure has dropped, remove the cap, top up the level to the "MAX" mark.
Be aware of the risk of burns when topping up the cooling system. Do not fill above the maximum level (indicated on the reservoir).
Chevrolet Sonic. Removing the Spare Tire and Tools
The compact spare tire and tools are located in the storage compartment in the
rear of the vehicle. The jack and tools are stored below the spare tire.
1. Extension
2. Jack
3. Wheel Wrench
4. ...
Ford Fiesta. Capacities and Specifications
Engine Specifications
Drivebelt Routing
1.0L EcoBoost
1.6L Duratec-16V Ti-VCT
1.6L EcoBoost
Motorcraft Parts
1 Failure to use the correct air filter element may result in severe engine
damag ...
Honda Fit. VSA® (Vehicle Stability Assist), aka ESC (Electronic Stability Control),
System
VSA® helps to stabilize the vehicle during cornering if the vehicle turns
more or less
than what was intended. It also assists in maintaining traction on slippery
surfaces.
It does so by regu ...