It is only possible to change from one gear to another if the vehicle speed and engine speed permit; otherwise, the gearbox will operate temporarily in automatic mode.
D disappears and the gears engaged
appear in succession in the instrument panel.
If the engine speed is too low or too high, the gear selected flashes for a few seconds, then the actual gear engaged is displayed. It is possible to change from position D (automatic) to position M (manual) at any time. When the vehicle is stationary or moving very slowly, the gearbox selects gear M1 automatically.
The sport and snow programmes do not operate in manual mode.
Invalid value during manual operation
This symbol is displayed if a gear
is not engaged correctly (selector between two positions).
Chevrolet Sonic. Selecting the Alert Timing
The Collision Alert control is on the steering wheel. Press COLLISION ALERT to
set the alert timing to far, medium, near or off. The first button press shows the
current control setting on the D ...
Fiat Punto. Roof rack/ski rack
FASTENERS
3-door versions
Move the seal aside in the points shown in the figure to reach the
fasteners.
The rear fasteners are in the areas indicated by the printed
reference
mark on the rea ...
Seat Ibiza. Content
This manual is structured to give you the information you need as quickly and
clearly as possible. The contents of this Manual are grouped into relatively short
sections making up chapters (e.g. â ...