Your vehicle has been approved in accordance with the new ISOFIX regulation .
The seats, represented below, are fitted with regulation ISOFIX mountings:
There are three rings for each seat:
- two rings A , located between the vehicle seat back and cushion, indicated by a label,
- a ring B behind the seat for fixing the upper strap, referred to as the T op Tether.
This ISOFIX mounting system provides fast, reliable and safe fitting of the child seat in your vehicle.
When fitting an ISOFIX child seat to the left hand rear seat, before fitting the seat, first move the centre rear seat belt towards the middle of the vehicle, so as to avoid the seat interfering with the operation of the seat belt. The ISOFIX child seats are fitted with two latches which are secured on the two rings A. Some seats also have an upper strap, known as the Top Tether, which is attached to ring B. To attach this strap, raise or remove the vehicle seat's head restraint then pass the strap over the backrest. Attach the strap by its hook on ring B and then fully tighten the upper strap.
The incorrect installation of a child seat in a vehicle compromises the child's protection in the event of an accident.
For information regarding the ISOFIX child seats which can be installed in your vehicle, refer to the table showing the locations for installing ISOFIX child seats.
Skoda Fabia. Changing a wheel
Remove the full wheel trim » page 155 or caps » page 155.
First of all slacken the anti-theft wheel bolt and then the other wheel
bolts
Jack up the vehicle until the wheel that needs changi ...
Mazda 2. Hill Launch Assist (HLA)
Hill Launch Assist (HLA) is a function
which assists the driver in accelerating
from a stop while on a slope. When
the driver releases the brake pedal and
depresses the accelerator pedal while
on ...
Skoda Fabia. Fastening systems
ISOFIX system attachment points
Fig. 16 ISOFIX system label
There are two locking eyes between the rear exterior seats for fixing the
ISOFIX system child seat in place.
The places are marked ...