Renault Clio: Access to towing points
Unclip cover 4 or 6 by sliding a flat tool
(or the key integrated in the RENAULT
card) under the cover.
Tighten towing hitch 3 fully: as much
as possible by hand at first, then finish
tightening it using the wheelbrace or,
depending on the vehicle, the lever.
Only use the towing eye 3 and the
wheelbrace located under the luggage
compartment carpet in the tool kit
(please refer to the information under
“Tools” in Section 5).
Do not leave the tools unsecured
inside the vehicle as
they may come loose under
braking. |
READ NEXT:
The following advice will enable you to carry out quick, temporary repairs.
For safety reasons you should always contact
an approved Dealer as soon as possible.
Using the RENAULT card
The Renault Clio IV, produced from 2014 to 2019, offers a range of technical specifications that contribute to its performance and versatility. It is available with gasoline and diesel engine options,
The information shown on the vehicle
identification plate should be
quoted on all correspondence or
orders.
The presence and location of the information
depends on the vehicle.
Vehic
SEE MORE:
K9K, and 750 or 752
REMOVAL
Position the vehicle on a two-post lift.
Remove the scuttle panel grille (see Scuttle panel grille: Removal -
Refitting).
Disconnect the exhaust gas recirculation solenoid valve electrical
wiring harness (4).
Detach the electric wiring harness.
Disconnect
LEFT-HAND DRIVE, and CLIMATE CONTROL
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components) (
MR 394, 88C, Airbag and pretensioners).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, B
© 2016-2024 Copyright Renault Clio Owners Club