Renault Clio: Parking sensor

Operating principle

Ultrasonic detectors, installed in the rear bumper (depending on the vehicle), measure the distance between the vehicle and an obstacle whilst reversing.

This measurement is indicated by beeps which become more frequent the closer you come to the obstacle, until they become a continuous beep when the vehicle is approximately 30 centimetres from the obstacle.

NB: make sure that the ultrasonic sensors are not obscured (by dirt, mud, snow, etc.).

Renault Clio. Operating principle


NB: depending on the vehicle, screen 1 shows the vehicle surroundings alongside the beeps.

Operation

Renault Clio. Operation


When reverse gear is selected, most objects which are less than approximately 1.20 metres from the rear of the vehicle are detected, a beep sounds and, depending on the vehicle, display 1 lights up.

This function is an additional aid that indicates the distance between the vehicle and an obstacle whilst reversing, using sound signals.

Under no circumstances should it replace the driver’s care or responsibility whilst reversing.

The driver should always look out for sudden hazards during driving: always ensure that there are no moving obstacles (such as a child, animal, pram or bicycle, etc.) or small, narrow objects such as stones or posts in your path when manoeuvring.

Adjusting the parking distance control volume

Renault Clio. Adjusting the parking distance control volume


Depending on the vehicle, certain settings can be adjusted from the touchscreen 1. Please see the equipment instructions for further information.

Deactivating the system

Renault Clio. Deactivating the system


Press switch 2 to deactivate the system.

The indicator light built into the switch lights up to remind you that the system is deactivated.

Pressing the switch again will reactivate the system and switch off the indicator light.

Depending on the vehicle, you can deactivate the parking distance control from the touch-screen. Please see the equipment instructions for further information.

Operating faults

Depending on the vehicle, when the system detects an operating fault, the message “check parking distance control” appears on the instrument panel, accompanied by the warning light and a beep lasting approximately
5 seconds. Please contact an authorised dealer.

An impact to the underside of the vehicle while manoeuvring (e.g.: striking a post, raised kerb or other street furniture) may result in damage to the vehicle (e.g.: deformation of an axle).

To avoid any risk of accident, have your vehicle checked by an approved Dealer.

READ NEXT:

 Reversing camera

Operation Moving into reverse gear, the 1 camera (located on the tailgate on five-seater versions or near the number plate lights on estate versions) provides a view of the area behind the ve

 Automatic gearbox

Selector lever 1 P: park R: reverse N: Neutral D: automatic mode M: manual mode +: upper gear –: lower gear 4: displays the gear engaged in manual mode. Note: Press the button 2 to go

 Your comfort

The Renault Clio IV (2014-2019) is designed with your comfort in mind. It features a well-crafted interior with quality materials and thoughtful ergonomics. The seats offer excellent support and adjus

SEE MORE:

 Clutch circuit: Bleed

JH3 or JR5 or TL4 Bleed in the event of: dead travel, pedal at mid-travel, pedal to the floor, poor gear changing. I - PRECAUTIONS DURING REPAIR Risks relating to contamination. The hydraulic clutch system is very sensitive to contamination. The risks caused by contamination are: impossibl

 Door mirror: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Unclip the trim (1). II - OPERATION FOR REMOVAL OF PART CONCERNED Remove: the sealing foam (2), the bolts (3) the door mirror. Disconnect the supply connectors (depending on equipment level). SCHOOL VEHICLE Unclip the casing (4). R

© 2016-2024 Copyright Renault Clio Owners Club