B-Class car manuals
Seat Ibiza: Head restraints -  Seats and stowage - Operating instructions - Seat Ibiza Owners Manual

Seat Ibiza: Head restraints

Seat Ibiza Owners Manual

Correct adjustment of head restraints

Properly adjusted head restraints are an important part of occupant protection and can reduce the risk of injuries in most accident situations.


Fig. 72 Front view: head restraints and seat belts correctly adjusted


Fig. 73 Side view: head restraints and seat belts correctly adjusted

– Adjust the head restraint so that its upper edge is at the same level as the top of your head, or as close as possible to the same level as the top of your head and, as a very minimum at eye level ⇒ fig. 72 and ⇒ fig. 73.

Adjusting the head restraints.

WARNING

• Travelling with the head restraints removed or improperly adjusted increases the risk of severe injuries.

• Improperly adjusted head restraints could lead to death in the event of a collision or accident.

• Incorrectly adjusted head restraints also increase the risk of injury during sudden or unexpected driving or braking manoeuvres.

• The head restraints must always be adjusted according to the occupant's size.

Removing or adjusting head restraints

The head restraints can be adjusted by moving them up and down.


Fig. 74 Adjusting and removing the head restraints

Adjusting height (front seats)

– Press the button on the side and pull upwards to the desired position. – To lower the head restraint, press the button and push head restraint downwards. – Make sure that it engages securely into position.

Adjust height (rear outer seats)

– Press the button on the side and pull upwards or downwards to the desired position.

– Make sure that the head restraint engages securely in one of its positions.

Adjusting height (rear central seat)

– Press the button on the side and pull upwards to the desired position. – To lower the head restraint, press the button and push head restraint downwards. – Make sure that the head restraint engages securely in one of its positions.

Angle adjustment (front seats)

– Press the head restraint forward or back to the required position.

Removing the head restraint

– Push the head restraint up as far as it will go. – Press the button ⇒ fig. 74 (arrow). – Pull head restraint out of fitting without releasing the button.

Fitting the head restraint

– Insert the head restraint into the guides on the rear backrest. – Push head restraint down. – Adjust the head rest to suit body size.

WARNING

• Never drive if the head restraints have been removed. Risk of injury.

• Never drive if the head restraints are in an unsuitable position, there is a risk of serious injury.

• After refitting the head restraint, you must always adjust it properly for height to achieve optimal protection.

• Please observe the safety warnings, “Correct adjustment of head restraints”.


Note

• To fit and remove the rear head restraints, gently tilt the seat back forwards.

• When fitting the head restraints again, insert the tubes as far as possible into the guides without pressing the button.

    The importance of correct seat adjustment

    Front seats

    Other info:

    Chevrolet Sonic. Dinghy Towing All except RS Model with Automatic Transmission
    When dinghy towing a vehicle with an automatic transmission, the vehicle should be run at the beginning of each day and at each RV fuel stop for about five minutes. This will ensure proper lubrica ...

    Honda Fit. Remote Transmitter Care
    Replacing the Battery If the indicator does not come on when the button is pressed, replace the battery. Battery type: CR1616 1. Unscrew the cover with a small Phillipshead screwdriver. υ ...

    Chevrolet Sonic. Forward Collision Alert (FCA) System
    For vehicles with this feature, read the following section before using it. The Forward Collision Alert (FCA) system may help to avoid or reduce the harm caused by front-end crashes. FCA provides a ...

    Manuals For Car Models


    © 2016-2024 Copyright www.b-auto.net 0.0116