The ignition must be switched ON to use the turn and lane-change signals.
Direction Indicators
Move the signal lever down (for a left turn) or up (for a right turn) to the stop position. The signal will self-cancel after the turn is completed.
If the indicator light continues to fl ash after a turn, manually return the lever to its original position.
The direction indicators (green) in the instrument cluster fl ash according to the operation of the direction indicator lever to show which signal is working.
NOTE
Lane-Change Signals
Move the lever halfway toward the direction of the lane change—until the indicator fl ashes— and hold it there. It will return to the off position when released.
Three-Flash Turn Signal
To signal a lane change, operate the direction indicator lever up or down slightly and release. After releasing the lever, the direction indicator fl ashes three times.
NOTE
The three-fl ash turn signal function can be switched to operable/inoperable using the personalisation function.
Refer to Personalisation Features on page 9-13 .
Renault Clio. Tyre pressure
Label A
Open the driver’s door to read it.
Tyre pressures should be checked
when the tyres are cold.
If the tyre pressures cannot be checked
when the tyres are cold, increase the
press ...
Fiat Punto. Spray nozzles
Windscreen wiper
If the jet of fluid is inadequate, firstly check that there is fluid in the
reservoir: see “Checking fluid levels” in this section).
Then check that the nozzle holes are not ...
Nissan Micra. Jump starting
To start your engine with a booster battery, the
instructions and precautions below must be followed.
WARNING
If done incorrectly, jump starting can
lead to a battery explosion, resul ...