Renault Clio: On-board computer: general information
On-board computer 1
Depending on the vehicle, this includes
the following functions:
Display selection keys 2 and 3
Scroll through the following information
upwards (key 2) or downwards (key 3)
by pressing briefly and successively
(the display depends on the vehicle
equipment and country).
- total mileage and trip mileage recorder;
- fuel used;
- average fuel consumption;
- current fuel consumption;
- estimated range;
- distance travelled;
- average speed;
- distance before service;
- service counter;
- oil change counter;
- Reset the tyre pressure
- Cruise control and speed limiter programmed
speed
- Clock and temperature
- Trip log, operating faults and information
message readout
Resetting the trip mileage
With “trip mileage recorder” selected on
the display, press button 2 or 3 until the
mileage recorder resets to zero.
Resetting the journey
parameters (reset button)
With one of the trip parameters selected
as the display, press and hold button 2
or 3 until the display resets
Interpreting some of the
values displayed after
resetting
The values showing average fuel consumption,
range and average speed
will become more stable and reliable
the further you travel after pressing the
reset button.
For the first few miles after pressing
the reset key you will notice that the
range increases as you travel. This
range takes into account the average
fuel consumption since the last time the
reset button was pressed. Therefore,
the average fuel consumption may decrease
when:
- the vehicle stops accelerating;
- the engine reaches its operating
temperature (if the engine was cold
when the reset key was pressed);
- when driving from an urban area
onto the open road.
Automatic resetting of the
journey parameters
Resetting occurs automatically when
the maximum value of any of the parameters is exceeded.
READ NEXT:
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND
COUNTRY
Examples of selections
Interpreting the display selected
a) Total mileage and trip
Information messages
These can help in the vehicle starting phase, or give information about a
selection or a driving status.
Examples of information messages are given in the following pages.
SEE MORE:
Courtesy light
Press switch 2 for:
permanent lighting;
intermittent lighting, which comes
on when a door is opened. It only
switches off after a time delay and
when the doors concerned have
been closed correctly;
lighting switches off immediately.
Map reading lights
Press sw
K9K, and 750 or 752 or 766 or 768
To configure the injectors, (see MR 394 Fault finding,
Diesel Injection, Configuration and programming).
Diesel injector: Removal - Refitting
K9K, and 764 or 772
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions
© 2016-2024 Copyright Renault Clio Owners Club