B-Class car manuals
Skoda Fabia: Changing a wheel - Changing a wheel - Emergency equipment, and self-help - Do-it-yourself - Skoda Fabia Owners Manual

Skoda Fabia: Changing a wheel

Skoda Fabia Owners Manual

  • Remove the full wheel trim » page 155 or caps » page 155.
  • First of all slacken the anti-theft wheel bolt and then the other wheel bolts
  • Jack up the vehicle until the wheel that needs changing is clear of the ground
  • Unscrew the wheel bolts and place them on a clean surface (cloth, paper, etc.).
  • Remove the wheel carefully.
  • Attach the spare wheel and slightly screw on the wheel bolts.
  • Lower the vehicle.
  • Tighten the opposite wheel bolts alternately (cross-wise) with the wheel wrench. Tighten the anti-theft wheel bolt last
  • Reinstall the wheel trim/wheel trim cap or the caps.

Note

  • All bolts must be clean and must turn easily.
  • Under no circumstances grease or oil the wheel bolts!
  • When fitting unidirectional tyres, ensure that the direction of rotation is correct » page 153, Unidirectional tyres.

Subsequent steps

The following steps must also be performed after changing the wheel.

  • Stow and attach the replaced wheel in the spare wheel well using a special screw » page 154, Spare and back-up wheel.
  • Stow the tool kit in the space provided and secure using the strap.
  • Check the tyre pressure on the installed spare wheel as soon as possible.
  • Have the tightening torque of the wheel bolts checked with a torque wrench as soon as possible.
  • Change the damaged wheel or consult a specialist garage about repair possibilities.

Note

  • If it is determined that the wheel bolts are corroded and difficult to turn when changing the wheel, the bolts must be replaced before checking the tightening torque.
  • Drive cautiously and only at a moderate speed until the tightening torque has been checked.
    Changing a wheel

    Loosening/tightening wheel bolts

    Other info:

    Peugeot 208. Indicator and warning lamps
    Visual indicators informing the driver that a system is in operation, switched off or has a fault. When the ignition is switched on Certain warning lamps come on for a few seconds in the instr ...

    Renault Clio. Transporting objects in the boot
    Always position the objects transported so that the largest surface is against: The rear bench seatback for normal loads (example A). The front seatbacks with the rear seatbacks ...

    Chevrolet Sonic. Daytime Running Lamps (DRL)
    DRL can make it easier for others to see the front of your vehicle during the day. Fully functional DRL are required on all vehicles first sold in Canada. This indicator light turns on in the ins ...

    Manuals For Car Models



    © 2016-2021 Copyright www.b-auto.net 0.0214