Unscrew cap and check that the fluid level in the reservoir is at maximum.
Fluid level in the reservoir shall not exceed the MAX mark.
If fluid has to be added, it is suggested to use the brake fluid in table “Fluids and lubricants” (see chapter “Technical specifications”). When opening cap take the utmost care to prevent impurities entering the tank.
For topping up, always use a funnel with integrated filter with mesh equal to or lower than 0.12 mm.
IMPORTANT Brake fluid absorbs moisture; for this reason, if the car is mainly used in areas with a high degree of atmospheric humidity, the fluid should be replaced at more frequent intervals than specified in the “Service schedule”.
Make sure that the
highly corrosive brake fluid does not drip onto the paintwork. If it does, wash it off immediately with water. |
Brake fluid is poisonous
and highly corrosive. In the event of accidental contact, wash the parts involved immediately with neutral soap and water, then rinse thoroughly. Call the doctor immediately if the fluid is swallowed. |
The symbol
on the container indicates synthetic brake fluid, distinguishing it from the mineral kind. Using mineral fluids irreversibly damages the special braking system rubber seals. |
Honda Fit. Changing the Engine Oil and Oil Filter
You must change the engine oil and oil filter regularly in order to maintain
the
engine’s lubrication. The engine may be damaged if they are not changed
regularly.
Change the oil and filter ...
Seat Ibiza. Driving economically and with respect for theenvironment
General Observations
Fuel consumption, environmental pollution and wear to the engine, brakes and
tyres depends in large part on your driving style. Fuel consumption may be reduced
from 10 to 15 ...
Mazda 2. Drive Selection
Drive selection is a system to switch the vehicle's drive mode. When the
sport mode is
selected, vehicle's response against accelerator operation is enhanced. Use the
sport mode
when higher vehi ...