Due to legal requirements in some Canadian Provinces, your vehicle may be required to be in what is called the “ready condition” for an Inspection/Maintenance (I/M) test of the emission control system.
The vehicle is set to the “ready condition” when it is driven through certain driving patterns. Usually, the ready condition can be obtained by ordinary usage of the vehicle.
If a powertrain system component is repaired or the battery is disconnected, the vehicle may be reset to a “not ready” condition. Before taking the I/M test, check the vehicle’s inspection/maintenance test readiness condition.
Place the ignition switch in the ON position without starting the engine. If the Malfunction Indicator Light (MIL) comes on steady for 20 seconds and then blinks for 10 seconds, the I/M test condition is “not ready”. If the MIL does not blink after 20 seconds, the I/M test condition is “ready”. Contact a NISSAN dealer to set the “ready condition” or to prepare the vehicle for testing.
Renault Clio. Electric windows
These systems operate with the ignition
on or off, until one of the front doors
is opened (limited to about 3 minutes).
Safety of rear occupants
The driver can prevent operation
of the ...
Peugeot 208. Particle emissions filter (Diesel)
The start of saturation of the particle filter is indicated by the temporary
illumination of this warning lamp accompanied by a warning message in the screen.
As soon as the traffic conditions pe ...
Chevrolet Sonic. When Should an Airbag Inflate?
This vehicle is equipped with airbags. See Airbag System. Airbags
are designed to inflate if the impact exceeds the specific airbag system's deployment
threshold. Deployment thresholds are used to ...