BLUETOOTH® is a
trademark owned by
Bluetooth SIG, Inc.
and licensed to Visteon
The system allows hands-free operation of the Bluetooth® Phone System.
If the vehicle is in motion, some commands may not be available so full attention may be given to vehicle operation.
Initialization
When the ignition switch is placed in the ON
position, NISSAN Voice Recognition is initialized,
which takes a few seconds. If the
button is
pressed before the initialization completes, the
system will announce “Hands-free phone system
not ready” and will not react to voice commands.
Giving voice commands
To operate NISSAN Voice Recognition, press
and release the button located on
the
steering wheel. After the tone sounds, speak a
command.
The command given is picked up by the microphone, and voice feedback is given when the command is accepted.
Please try again.”Make sure the command is said exactly as prompted by the system and repeat the command in a clear voice.
Voice Prompt Interrupt
In most cases you can interrupt the voice feedback
to speak the next command by pressing
the button on the steering wheel.
After
interrupting the system, wait for a beep before
speaking your command.
One Shot Call
To use the system faster, you may speak the
second level commands with the main menu
command on the main menu. For example, press
the button and after the tone say,
“Call
Redial”.
Operating tips
To get the best performance out of the system, observe the following:
Chevrolet Sonic. Tire and Loading Information Label
A vehicle-specific Tire and Loading Information label is attached to the vehicle's
center pillar (B-pillar). The Tire and Loading Information label shows the number
of occupant seating positions ...
Nissan Micra. Automatic transmission (if so equipped)
The Automatic Transmission (A/T) in your vehicle
is electronically controlled to produce maximum
power and smooth operation.
The recommended operating procedures for this
transmission are shown ...
Renault Clio. Ashtray, cigarette lighter
Cigarette lighter 1
With the ignition on, push in the cigarette
lighter 1. It will spring back with a
click when it is ready. Pull it out to use.
After use, replace it without pushing it
al ...