Renault Clio: Operating faults

The following advice will enable you to carry out quick, temporary repairs. For safety reasons you should always contact an approved Dealer as soon as possible.

Using the RENAULT card

POSSIBLE CAUSES

WHAT TO DO

The RENAULT card does not lock or unlock the doors. Card battery is flat. Replace the battery. You can still lock/ unlock and start your vehicle (refer to the information on “Locking, unlocking the opening elements” in Section 1 and “Starting, stopping the engine” in Section 2).
Use of appliances operating on the same frequency as the card (mobile phone, etc.). Stop using the equipment or use the integrated key (refer to the information on “Locking, unlocking the opening elements” in Section 1).
Vehicle located in a high electromagnetic radiation zone.

Vehicle battery flat.

Use the key integrated in the card (refer to the information on “Locking, unlocking the opening elements” in Section 1).
The vehicle is started. With the engine running, the card’s locking/ unlocking device is blocked. Turn off the ignition.
The instrument panel indicator lights are weak or fail to light up and the starter does not turn Battery terminals not tight, battery terminals disconnected or oxidised. Retighten or reconnect the terminals, or clean them if they are oxidised.
Discharged battery or not operational. Connect another battery to the faulty battery. Refer to information on “Battery: troubleshooting” in Section 5 or replace the battery if necessary.

Do not push the vehicle if the steering column is locked.

Faulty circuit. Consult an approved dealer.
The engine will not start. Starting conditions are not fulfilled. Please refer to the information on “Starting, stopping the engine” in Section 2.
The RENAULT “hands-free” card does not work. Insert the card in the card reader in order to start the engine.

Please refer to the information on “Starting, stopping the engine” in Section 2.

The engine cannot be switched off. Card not detected. Insert the card in card reader.
Electronic fault. Press the starter button quickly five times
The steering column remains locked. Steering wheel locked. Move the steering wheel while pressing the engine start button (please refer to Section 2 “Starting, stopping the engine”).
Faulty circuit. Consult an approved dealer.


On the road

POSSIBLE CAUSES

WHAT TO DO

Vibrations. Tyres not inflated to correct pressures, incorrectly balanced or damaged. Check the tyre pressures: if this is not the problem, have them checked by an approved Dealer.
White smoke from the exhaust. In the diesel version, this is necessarily a fault. Smoke may be caused by particle filter regeneration. Please refer to the information on “Special features of diesel versions” in Section 2.
Smoke under the bonnet. Short-circuit or cooling system leak. Stop, switch off the ignition, stand away from the vehicle and contact an approved dealer.
The oil pressure warning light comes on: while cornering or braking The level is too low. Top up the engine oil level (refer to the information on “Engine oil level: topping up, filling” in Section 4).
is slow to go out or remains lit under acceleration Loss of oil pressure. Stop the vehicle and contact an approved Dealer.
Steering becomes heavy. Assistance overheating. Consult an approved dealer.
The engine is overheating. The coolant temperature indicator is in the warning zone and warning light comes on. Engine cooling fan not working. Stop the vehicle, switch off the engine and contact an approved dealer.
Coolant leaks. Check the coolant reservoir: it should contain fluid. If there is no coolant, consult an approved dealer as soon as possible.
Coolant boiling in the coolant reservoir. Mechanical fault: damaged cylinder head gasket. Stop the engine.

Contact an approved dealer.

Radiator: If there is a significant lack of coolant, remember that it must never be topped up using cold coolant while the engine is very warm. After any procedure on the vehicle which has involved even partial draining of the cooling system, it must be refilled with a new mixture prepared in the correct proportions. Reminder: only products approved by our Technical Department may be used for this purpose.

Electrical equipment

POSSIBLE CAUSES

WHAT TO DO

The wipers do not work Wiper blades stuck. Free the blades before using the wipers
Faulty electrical circuit. Consult an approved dealer.
Fuse damaged Replace the fuse, refer to the information on “Fuses”.
The wiper does not stop. Faulty electrical controls. Consult an approved dealer.
Direction indicators flashing more quickly. Blown bulb. See information on “Headlights: changing bulbs” or “Rear and side lights: changing bulbs”.
The direction indicators do not work. Faulty electrical circuit or control. Consult an approved dealer.
Fuse damaged. Replace the fuse, refer to the information on “Fuses”.
The lights do not come on or go off. Faulty electrical circuit or control. Consult an approved dealer.
Fuse damaged. Replace the fuse, refer to the information on “Fuses”.
Traces of condensation in the lights. Traces of condensation may be a natural phenomenon caused by variations in temperature.

In this case, the traces will disappear slowly once the lights are switched on.

The front seat belt reminder light comes on when the seat belts are fastened. An object is stuck between the floor and the seat and is disrupting the operation of the sensor. Remove all objects from underneath the front seats.

READ NEXT:

 Technical specifications

The Renault Clio IV, produced from 2014 to 2019, offers a range of technical specifications that contribute to its performance and versatility. It is available with gasoline and diesel engine options,

 Vehicle identification plate

The information shown on the vehicle identification plate should be quoted on all correspondence or orders. The presence and location of the information depends on the vehicle. Vehic

 Engine identification plate

Please quote the information on the engine plate or label A in all correspondence or orders. (Location varies depending on engine) Engine type. Engine suffix. Engine number.

SEE MORE:

 Oil decanter: Removal - Refitting

F4R REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove: the throttle valve (see 12A, Fuel mixture, Throttle valve: Removal - Refitting, 12A-33), the intake distributor (see 12A, Fuel mixture, Inlet distribut

 F4R

IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5). WARNING To prevent damage to the wiring harness when refitting, observe the original routing. REMOVAL I - REMOVAL PR

© 2016-2024 Copyright Renault Clio Owners Club