The brake/clutch master cylinder reservoir is filled with DOT 3 brake fluid as indicated on the reservoir cap. See Engine Compartment Overview for the location of the reservoir.
There are only two reasons why the fluid level in the reservoir might go down:
Do not top off the brake/clutch fluid. Adding fluid does not correct a leak. If fluid is added when the linings are worn, there will be too much fluid when new brake linings are installed. Add or remove brake fluid, as necessary, only when work is done on the brake/clutch hydraulic system.
Warning
If too much brake fluid is added, it can spill on the engine and burn, if the engine is hot enough. You or others could be burned, and the vehicle could be damaged. Add brake fluid only when work is done on the brake/clutch hydraulic system.
When the brake/clutch fluid falls to a low level, the brake warning light comes on. See Brake System Warning Light.
Honda Fit. Maximum Load Limit
The maximum load for your vehicle is 850 lbs (385 kg).
See Tire and Loading Information label attached to the driver’s doorjamb.
This figure includes the total
weight of all occupants, cargo, ...
Skoda Fabia. Spare and back-up wheel
Fig. 136 Fixing the back-up or spare wheel
The spare wheel is located in a well under the floor covering in the boot and
is
fixed in place with a special bolt » Fig. 136.
Taking the wheel ou ...
Fiat Punto. Using the rear central seat belt
Seat belt without reel mechanism
To fasten the seat belt: insert the tongue (A) into the buckle (B), until
you hear it click.
To unfasten the seat belt: press button (C).
To adjust the belt: s ...