
The engine oil life system calculates engine oil life based on vehicle use and
displays the
%CHANGE message on the
DIC when it is necessary to change the engine oil and filter.
Remember, the oil life display must be reset after each oil change. It will not reset itself.
Resetting the Oil Life System
1. Press the MENU button to show Remaining Oil Life on the display. This display shows an estimate of the oil’s remaining useful life. If 99% is displayed, that means that 99% of the current oil life remains.
2. To reset the engine oil life system, press the SET/CLR button while the oil life display is active. After a few seconds, there will be a single chime and the oil life will be reset to 100%.
Be careful not to reset the oil life display accidentally at any time other than when the oil has just been changed. It cannot be reset accurately until the next oil change.
See Engine Oil Life System.
Peugeot 208. Operation
Going into engine STOP mode
The "ECO" warning lamp
comes on in the instrument panel and the engine goes into standby:
- with a manual gearbox , at speeds below 12 mph (20 km/h), when yo ...
Mazda 2. Emergency Stop Signal System
Your Mazda is equipped with an
emergency stop signal system that is
designed to determine whether you are
depressing the brake pedal with greater
force than during normal braking such
as in a sit ...
Skoda Fabia. Useful equipment
WARNING
Do not place anything on the dash panel. These objects might
slide or fall
down while you are driving (under acceleration or when cornering) and
could distract you from the traffic ...