1. Open the hood. See Hood.
2. For the driver side bulb, remove the windshield washer bottle filler neck by turning it one-quarter turn counterclockwise and pulling it straight up and out of the bottle.
3. Remove the headlamp bulb access cover.
4. Turn the bulb counterclockwise and pull straight back.
5. Disconnect the wiring harness connector from the bulb.
6. Install the new bulb in the headlamp assembly by turning clockwise.
7. Reconnect the wiring harness connector.
8. Install the headlamp bulb access cover.
9. For the driver side bulb, replace the windshield washer bottle filler neck by turning it one-quarter turn clockwise into the bottle.
Fiat Punto. Refitting the standard wheel
Proceed as follows:
Following the procedure described previously, raise the car and
remove the spare wheel;
Make sure the contact surfaces between wheel and hub are clean so
that the fas ...
Seat Ibiza. Rear seat bench
Folding down rear seats
Fig. 77 Folding up the rear seat cushion
Fig. 78 Button for unlocking the rear backrest
Folding seat down
– Remove the head restraint. – Pull the front edge of the ...
Citroen C3. Mats
Removable component which protects
the carpet against exterior dirt.
Fitting
When fi tting the mat for the fi rst time,
on the driver's side, use only the fi xings
provided in the wallet attac ...