
Visually check the brake/clutch fluid reservoir to make sure the fluid level is at the MIN (minimum) line on the side of the reservoir. The brake/ hydraulic clutch fluid system should be closed and sealed.
Do not remove the cap to check the fluid level or to top off the fluid level. Remove the cap only when necessary to add the proper fluid until the level reaches the MIN line.
Peugeot 208. Changing a fuse
Before changing a fuse:
the cause of the failure must be identified and rectified,
all electrical consumers must be switched off,
the vehicle must be immobilised with the ignition off,
ident ...
Skoda Fabia. Changing a wheel
Remove the full wheel trim » page 155 or caps » page 155.
First of all slacken the anti-theft wheel bolt and then the other wheel
bolts
Jack up the vehicle until the wheel that needs changi ...
Peugeot 208. Programming
Turn thumb wheel 1 to the "LIMIT" position: the speed limiter mode is selected
but is not switched on (PAUSE).
You do not have to switch the speed limiter on in order to set the speed.
...