The vehicle's rear seats have adjustable head restraints in the outboard seating positions.
The height of the head restraint can be adjusted. Pull the head restraint up to raise it. Try to move the head restraint to make sure that it is locked in place.
To lower the head restraint, press the button, located on the top of the seatback, and push the head restraint down. Try to move the head restraint after the button is released to make sure that it is locked in place.
Rear outboard head restraints are not designed to be removed.
Fiat Punto. Extending the boot
Single rear seat
Proceed as follows:
fasten the seat buckles to the tabs on the seat back (as shown by
arrows);
check that the webbing (A) of each of the two side seat belts is
inserted int ...
Peugeot 208. Programming
Turn thumb wheel 1 to the "CRUISE" position: the cruise control mode is selected
but is not switched on (PAUSE).
Set the programmed speed by accelerating to the required speed, then pre ...
Renault Clio. Engine coolant
With the engine switched off and on
level ground, the level when cold must
be between the MINI and MAXI marks
on reservoir 1.
Top this level up when cold before it
reaches the MINI mark.
...