
1. With your foot off the accelerator pedal, turn the ignition to START. When the engine cranks, let go of the key. The idle speed will go down as the engine gets warm.
The vehicle has a Computer-Controlled Cranking System. It assists in starting the engine and protects components. If the ignition key is turned to START and then released when the engine begins cranking, the engine will continue cranking for a few seconds or until the engine starts. If the engine does not start and the key is held in START, cranking will be stopped after 15 seconds to prevent damage. To prevent gear damage, cranking is not allowed if the engine is running. Engine cranking can be stopped by turning the ignition key to ACC/ ACCESSORY or LOCK/OFF.
Caution
Holding the key in START for longer than 15 seconds at a time will cause the battery to be drained much sooner. And the excessive heat can damage the starter motor. Wait about 15 seconds between each try to help avoid draining the battery or damaging the starter.
2. If the engine does not start, wait about 15 seconds and try again. Wait about 15 seconds between each try.
When the engine has run about 10 seconds to warm up, the vehicle is ready to be driven. Do not run the engine at high speed when it is cold.
If the weather is below freezing (0°C or 32°F), let the engine run for a few minutes to warm up.
3. If the engine still will not start, or starts but then stops, it could be flooded with too much gasoline. Try pushing the accelerator pedal all the way to the floor and holding it there as you hold the key in START for about three seconds. If the vehicle starts briefly but then stops again, do the same thing, but this time keep the pedal down for five or six seconds. This clears the extra gasoline from the engine.
Caution
If you add electrical parts or accessories, you could change the way the engine operates. Any resulting damage would not be covered by the vehicle warranty. See Add-On Electrical Equipment.
Peugeot 208. Programming
Turn thumb wheel 1 to the "CRUISE" position: the cruise control mode is selected
but is not switched on (PAUSE).
Set the programmed speed by accelerating to the required speed, then pre ...
Skoda Fabia. Interior lights
Interior lighting - version 1
Fig. 45 Interior lighting – version 1
Positions of sliding switch A » Fig. 45.
Switch on
Switch off (middle position)
Control by the door contact
switch
...
Skoda Fabia. New tyres
Only fit radial tyres of the same type, size (rolling circumference) and the
same
tread pattern on one axle on all four wheels.
The tyre/wheel combinations which are approved for your vehicle ar ...