
Engaging reverse gear
Raise the ring under the knob and push the gear lever to the left then forwards.

Only engage reverse gear when the vehicle is stationary with the engine at idle.
As a safety precaution and to facilitate starting of the engine:
- always select neutral, - press the clutch pedal.
Renault Clio. To refit a wheel
A wheel size larger than 15” cannot
be installed under the vehicle.
To carry out this operation, the cable
must be unwound.
If the cable has been wound back up on
its ow ...
Skoda Fabia. Heating, ventilation, cooling
The heating effect is dependent upon the coolant temperature, thus full heat
output only occurs when the engine has reached its operating temperature.
If the cooling system is switched on, the tem ...
Skoda Fabia. Lights
The lights work only with the ignition on, unless otherwise stated.
The layout of the controls on right-hand drive vehicles partially differs
from
that shown in » Fig. 40 on page 56. The symbols ...