Renault Clio: Engine oil level: topping up, filling

Renault Clio IV (2014-2019) Owners Manual / Maintenance / Engine oil level: topping up, filling

Topping up/filling

Renault Clio. Topping up/filling


The vehicle must be parked on level ground and the engine should be cold (for instance, before the engine is started up for the first time in the day).

Before performing any action in the engine compartment, the ignition must be switched off by pressing the engine stop button (please see the information on “Starting, stopping the engine” in Section 2).

Renault Clio. Topping up/filling


Once the operation has been completed, ensure that the dipstick is pushed in as far as it will go and that the cap is completely screwed in.

Renault Clio. Topping up/filling


In order to prevent splashback, it is recommended that a funnel be used when topping up/filling with oil.

Do not exceed the max level and do not forget to refit cap 1 and dipstick 2.

Oil change

Renault Clio. Oil change


Service interval: refer to the Maintenance Service Booklet for your vehicle.

Oil change capacity

Please refer to the maintenance document for your vehicle, or contact an authorised dealer.

Always check the engine oil level using the dipstick, as explained previously (it should never fall below the minimum level, or be over the maximum level on the dipstick).

READ NEXT:

 Engine oil grade

Refer to the Maintenance Service Booklet for your vehicle. Filling: take care when topping up the oil that no oil drips onto engine components - risk of fire. Remember to refit th

 Levels

 Engine coolant

With the engine switched off and on level ground, the level when cold must be between the MINI and MAXI marks on reservoir 1. Top this level up when cold before it reaches the MINI mark.

SEE MORE:

 Engine oil grade

Refer to the Maintenance Service Booklet for your vehicle. Filling: take care when topping up the oil that no oil drips onto engine components - risk of fire. Remember to refit the cap securely as there is a risk of fire if oil splashes onto hot engine components.

 Actuator module: Removal - Refitting

K9K, and JA5 (1) Clutch solenoid valve (2) Gear engagement solenoid valve (18) Gear engagement solenoid valve (4) Selection solenoid valve (5) Engagement sensor (20) Gear selection sensor (7) Solenoid valve unit pressure sensor (8) High pressure filter REMOVAL I - REMOVAL PREPARATION OPERATION IM

© 2016-2024 Copyright Renault Clio Owners Club