
After the “initial check”, it is possible to access the menu screen pressing
the button
.
To surf the menu press buttons + or –.
Important if after entering the menu no setting/adjustment is performed within
60 seconds, the system exits the
menu automatically and returns to previously displayed screen. In this case the
last selected but not confirmed
setting (through button
) is not
stored and therefore the operation shall be repeated (this stands valid also
when
quitting the menu by pressing the
button).
When the car is running, it is possible to access only the reduced menu (for setting “speed limit”).
When the car is stationary access to the whole menu is enabled.
The following diagram shows the cases described.

Fiat Punto. If the battery is flat
IMPORTANT Battery recharging procedure is given as
information only since this operation shall be only
performed at a Fiat Dealership.
Charging should be slow at a low amp rating for 24
hours. C ...
Mazda 2. i-stop
The i-stop function automatically stops the engine when the vehicle is
stopped at a traffi c
light or stuck in traffi c, and then restarts the engine automatically to resume
driving. The
system ...
Skoda Fabia. Useful equipment
WARNING
Do not place anything on the dash panel. These objects might
slide or fall
down while you are driving (under acceleration or when cornering) and
could distract you from the traffic ...