B-Class car manuals
Mazda 2: Head Restraints - Seats - Essential Safety Equipment - Mazda2 Owners Manual

Mazda 2: Head Restraints

Mazda2 Owners Manual

Your vehicle is equipped with head restraints on front seats, rear outboard seats* and the rear centre seat * . The head restraints are intended to help protect you and the passengers from neck injury.

WARNING

Always drive with the head restraints installed when seats are being used and make sure they are properly adjusted.

In addition, always raise the head restraints mentioned below when they are being used: Driving with the head restraints adjusted too low or removed is dangerous. With no support behind your head, your neck could be seriously injured in a collision.

(Head restraints which must be raised for use)

  • All rear seat head restraints

Height Adjustment

Adjust the head restraint so that the centre is even with the top of the passenger's ears.

Height Adjustment


To raise a head restraint, pull it up to the desired position.

To lower the head restraint, press the stopcatch release, then push the head restraint down.

Front outboard seat

Front outboard seat


Rear outboard seat *

Rear outboard seat


Rear centre seat *

Rear centre seat


Removal/Installation

To remove the head restraint, pull it up while pressing the stop-catch.

To install the head restraint, insert the legs into the holes while pressing the stopcatch.

WARNING

Always drive with the head restraints installed when seats are being used and make sure they are properly installed: Driving with the head restraints not installed is dangerous. With no support behind your head, your neck could be seriously injured in a collision.

After installing a head restraint, try lifting it to make sure that it does not pull out: Driving with an unsecured head restraint is dangerous as the effectiveness of the head restraint will be compromised which could cause it to unexpectedly detach from the seat.

CAUTION

  • When installing a head restraint, make sure that it is installed correctly with the front of the head restraint facing forward. If the head restraint is installed incorrectly, it could detach from the seat during a collision and result in injury.
  • The head restraints on each of the front and rear seats are specialized to each seat. Do not switch around the head restraint positions. If a head restraint is not installed to its correct seat position, the effectiveness of the head restraint during a collision will be compromised which could cause injury.
    Rear Seat

    Seat Belt Systems

    Other info:

    Nissan Micra. Air conditioner operation
    Start the engine, turn the fan control dial to the desired position, and press the button to activate the air conditioner. When the air conditioner is on, cooling and dehumidifying functions are ...

    Seat Ibiza. Front airbags
    Description of front airbags The airbag system is not a substitute for the seat belts. Fig. 17 Driver airbag located in steering wheel Fig. 18 Front passenger airbag located in dash panel The ...

    Renault Clio. Steering wheel/Power-assisted steering
    Adjusting the steering wheel height and depth Pull lever 1 and place the steering wheel in the required position; push the lever beyond the point of resistance to lock the steering wheel in pl ...

    Manuals For Car Models


    © 2016-2024 Copyright www.b-auto.net 0.0182