Nissan Micra: Changing engine oil filter
Nissan Micra Owners Manual
- Park the vehicle on a level surface and apply the parking brake.
- Turn the engine off.
- Place a large drain pan under the oil filter B .
- Loosen the oil filter with an oil filter wrench by turning it counterclockwise. Then remove the oil filter by turning it by hand.
| CAUTION Be careful not to burn yourself. The engine oil may be hot. |
- Wipe the engine oil filter sealing surface with a clean rag.
| CAUTION Be sure to remove any old gasket material remaining on the sealing surface of the engine. Failure to do so could lead to engine damage. |
- Coat the gasket on the new filter with clean engine oil .
- Screw on the oil filter until a slight resistance
is felt, then tighten an additional 2/3 turn.
Oil filter tightening torque: 13 ft-lbs (18 N·m)
- Start the engine and check for leakage around the oil filter. Correct as required.
- Turn the engine off and wait more than 10 minutes. Check the oil level. Add engine oil by removing the oil filler cap A if necessary.
Other info:
Ford Fiesta. Child Safety
General Information
See the following sections for directions
on how to properly use safety restraints
for children.
WARNINGS
Always make sure your child is
secured properly in a device that is
approp ...
Mazda 2. Fuel Economy Monitor
For vehicles with type C/type D audio, the Control Status, Fuel Consumption,
and
Effectiveness are switched and displayed by operating each icon in the display.
In addition, after completing a t ...
Mazda 2. Battery
WARNING
Read the following
precautions carefully before using the battery or inspecting to
ensure safe and correct handling:
Always wear eye
protection when working near the battery:
Working w ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia