B-Class car manuals
Peugeot 208: Access to the spare wheel - Changing a wheel - Practical information - Peugeot 208 Owners Manual

Peugeot 208: Access to the spare wheel

Peugeot 208 Owners Manual


The spare wheel is installed in the boot under the floor.

According to country, the spare wheel may be steel, alloy or of the "space-saver" type. To gain access to it, refer to the paragraph "Access to the tools" on the previous page.


Taking out the wheel

  • Unscrew the yellow central bolt.
  • Raise the spare wheel towards you from the rear.
  • Take the wheel out of the boot.


Putting the wheel back in place

  • Put the wheel back in its housing.
  • Unscrew the yellow central bolt by a few turns then put it in place in the centre of the wheel.
  • Tighten fully until the central bolt clicks to retain the wheel correctly.


Put the box back in the centre of the wheel and clip it in place.

    Access to the tools

    Removing a wheel

    Other info:

    Citroen C3. Temporary puncture repair kit
    Complete system consisting of a compressor and an incorporated sealant cartridge which permits temporary repair of the tyre so that you can drive to the nearest garage. Access to the kit T ...

    Mazda 2. Towing
    Towing Caravans and Trailers (Europe/Russia/Turkey/Israel/South Africa) Your Mazda was designed and built primarily to carry passengers and cargo. If you tow a trailer, follow these instructions ...

    Fiat Punto. To close the bonnet
    Proceed as follows: hold the bonnet up with one hand and, with the other, remove rod (C) from recess (D) replace it in its clip; lower the bonnet at approx. 20 cm from the engine compartme ...

    Manuals For Car Models


    © 2016-2026 Copyright www.b-auto.net 0.0127