Peugeot 208: Coolant level
Peugeot 208 Owners Manual
The coolant level should be close to the "MAX" mark but should never exceed it.
When the engine is warm, the temperature of the coolant is regulated by the fan. This can operate with the ignition off.
For vehicles fitted with a particle emissions filter, the cooling fan may continue to run after stopping the vehicle, even if the engine is cold.
In addition, as the cooling system is pressurised, wait at least one hour after switching off the engine before carrying out any work. To avoid any risk of scalding, unscrew the cap by two turns to allow the pressure to drop. When the pressure has dropped, remove the cap and top up the level.
Changing the coolant
The coolant does not have to be changed.
Fluid specification
The coolant must conform to the manufacturer's recommendations.
Other info:
Fiat Punto. Identification data
You are advised to note the identification codes. The identification data
stamped and given on the plates and their position are the following:
Model plate
Chassis marking
Bodywork paint ...
Citroen C3. Alarm
System which protects and provides a
deterrent against the theft of your vehicle.
It provides two types of protection,
exterior and interior, as well as an antitamper
function.
Exterior perim ...
Skoda Fabia. Full wheel trim
Pulling off
Hook the clamp found in the vehicle tool kit » page 158 into the
reinforced
edge of the wheel trim.
Push the wheel wrench through the clamp, support on the tyre and pull
off ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia - Honda Pilot
- Volkswagen ID4
- Toyota Prius
