Peugeot 208: Moving off
Peugeot 208 Owners Manual
- Select position N.
- Press the brake pedal down fully.
- Start the engine.
N appears in the instrument panel
screen.
N flashes in the instrument panel, accompanied by an audible signal and a message in the instrument panel screen, if the gear lever is not in position N on starting.
Foot on brake flashes
on the instrument panel, accompanied by an audible signal and a message in the instrument
panel screen, if the brake pedal is not pressed on starting.
- Select automated mode (position A ), manual mode (position M ), or reverse (position R).
- Release the parking brake.
- Take your foot off the brake pedal, then accelerate.
AUTO and 1, 1 or R appears in the instrument panel screen.
Other info:
Fiat Punto. Identification data
You are advised to note the identification codes. The identification data
stamped and given on the plates and their position are the following:
Model plate
Chassis marking
Bodywork paint ...
Renault Clio. Attachment by seat belt
The table below summarises the information already shown in the diagram on
the following pages, to ensure the applicable
regulations are respected.
(1) RISK OF DEATH OR SERIOUS INJURY: ...
Chevrolet Sonic. Roof
Sunroof
On vehicles with this feature, the sunroof only operates when the ignition is
turned to ON/RUN or Retained Accessory Power (RAP) is active.
Open/Close: To open the sunroof, press and hol ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia - Honda Pilot
- Volkswagen ID4
- Toyota Prius
