B-Class car manuals
Peugeot 208: Operation - Stop & Start - Driving - Peugeot 208 Owners Manual

Peugeot 208: Operation

Peugeot 208 Owners Manual

Going into engine STOP mode

The "ECO" warning lamp
comes on in the instrument panel and the engine goes into standby:

- with a manual gearbox , at speeds below 12 mph (20 km/h), when you put the gear lever into neutral, and you release the clutch pedal.

- with a 5-speed electronic gearbox , at speeds below 5 mph (8 km/h), when you press the brake pedal or put the gear lever in position N .

A time counter calculates
the sum of the periods in STOP mode during a journey. It rests itself to zero every time the ignition is switched on with the key.

For your comfort, during parking manoeuvres, STOP mode is not available for a few seconds after coming out of reverse gear. STOP mode does not affect the functionality of the vehicle, such as for example, braking, power steering...

Never refuel with the engine in STOP mode; you must switch off the ignition with the key.

Special cases: STOP mode not available

STOP mode is not invoked when:

- the driver's door is open, - the driver's seat belt is not fastened, - the vehicle has not exceeded 6 mph (10 km/h) since the last engine start using the key,
- the engine is needed to maintain a comfortable temperature in the passenger compartment, - demisting is active,
- some special conditions (battery charge, engine temperature, braking assistance, ambient temperature...) where the engine is needed to assure control of a system.

The "ECO" warning lamp
flashes for a few seconds then goes off.

This operation is perfectly normal.

Going into engine START mode


The "ECO" warning lamp goes off and the engine starts:

- with a manual gearbox , when you depress the clutch pedal, - with an electronic gearbox :

● gear lever in position A or M , when you release the brake pedal, ● or gear lever in position N and the brake pedal released, when you move the gear lever to position A or M , ● or when you engage reverse gear.

Special cases: START invoked automatically

For reasons of safety and for your comfort, START mode is invoked automatically when:

- you open the driver's door, - you unfasten the driver's seat belt, - the speed of the vehicle exceeds 7 mph (11 km/h) with an electronic gearbox, - some special conditions (battery charge, engine temperature, braking assistance, ambient temperature...) where the engine is needed for control of a system.


The "ECO" warning lamp flashes for a few seconds, then goes off.

This operation is perfectly normal.

    Stop & Start

    Deactivation

    Other info:

    Chevrolet Sonic. DIC Operation and Displays
    The DIC has different displays which can be accessed by using the DIC buttons on the turn signal lever on the left side of the steering wheel. The DIC displays trip, fuel, and warning messages if ...

    Nissan Micra. Vents
    Center vents Adjust the air flow direction of the vents by moving the vent slides 1 . Side vents Adjust the air flow direction of the vents by opening, closing or rotating. ...

    Fiat Punto. Activation/deactivation (CITY function)
    To connect/disconnect the CITY function, push the button located on the central tunnel . Activation of this function is indicated by the word CITY on the instrument panel (see figures beside) ...

    Manuals For Car Models


    © 2016-2024 Copyright www.b-auto.net 0.0127