Peugeot 208: Starting using another battery
Peugeot 208 Owners Manual
Peugeot 208 / Peugeot 208 Owners Manual / Practical information / Battery / Starting using another battery
- Connect the red cable to the positive terminal (+) of the flat battery A , then to the positive terminal (+) of the slave battery B.
- Connect one end of the green or black cable to the negative terminal (-) of the slave battery B.
- Connect the other end of the green or black cable to the earth point C on your vehicle (engine mounting).
- Operate the starter, let the engine run.
- Wait until the engine returns to idle and disconnect the cables.
Other info:
Citroen C3. Wiper controls
System for selection and control of the
various front and rear wiping modes for
the elimination of rain and cleaning.
The vehicle's front and rear wipers are
designed to improve the driver's vi ...
Chevrolet Sonic. Passenger Sensing System
United States
Canada
The passenger sensing system turns off the front outboard passenger frontal airbag
and knee airbag (if equipped) under certain conditions. No other airbag is affected
by ...
Skoda Fabia. Full wheel trim
Pulling off
Hook the clamp found in the vehicle tool kit » page 158 into the
reinforced
edge of the wheel trim.
Push the wheel wrench through the clamp, support on the tyre and pull
off ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia - Honda Pilot
- Volkswagen ID4
- Toyota Prius
© 2016-2026 Copyright www.b-auto.net 0.0068