Peugeot 208: Stopping the vehicle
Peugeot 208 Owners Manual
Before switching off the engine, you can choose to:
- move to position N to engage neutral, - leave the gear engaged; in this case, it will not be possible to move the vehicle.
In both cases, you must apply the parking brake to immobilise the vehicle.
When immobilising the vehicle, with the engine running, you must place the gear lever in neutral N.
Before carrying out any work in the engine compartment, check that the gear lever is in neutral N and that the parking brake is applied.
Other info:
Mazda 2. Drive Selection
Drive selection is a system to switch the vehicle's drive mode. When the
sport mode is
selected, vehicle's response against accelerator operation is enhanced. Use the
sport mode
when higher vehi ...
Mazda 2. Saving Fuel and Protection of the Environment
How you operate your Mazda determines
how far it will travel on a tank of fuel. Use
these suggestions to help save fuel and
reduce CO2.
Avoid long warm-ups. Once the engine
runs smoothly, beg ...
Peugeot 208. Switching the engine off
Immobilise the vehicle.
Turn the key fully towards you to position 1 (Stop) .
Remove the key from the ignition switch.
Free wheeling
For safety reasons, do not free wheel. If free wheeling, ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia - Honda Pilot
- Volkswagen ID4
- Toyota Prius
