Renault Clio: RENAULT card: battery
Replacing the battery
When the message “KEYCARD BATTERY LOW” appears on the instrument panel, replace the RENAULT card battery, press button 1 pulling on emergency key 2, then unclip the cover 3 using tab 4.
Remove the battery by pressing on one side (movement A) and by lifting the other (movement B) then replace it, ensuring the polarity and model, shown on cover 3 are respected.
When refitting, proceed in the reverse order, then press one of the buttons on the card four times, close to the vehicle: the next time the vehicle is started, the message will disappear.
Note: it is not advisable to touch the electronic circuit or contacts on the RENAULT card when replacing the battery.
| Check that the cover is clipped shut. |
| The batteries are available from approved Dealers, and their service life approximately two years. Check that there is no dye on the battery: risk of an incorrect electrical contact. |
Operating faults
If the battery is too weak to ensure correct operation, you may start (insert the RENAULT card in the card reader) and lock/unlock the vehicle (refer to the information on “Locking/unlocking the doors” in Section 1).
| Do not throw away your used batteries; give them to an organisation responsible for collecting and recycling batteries. |
READ NEXT:
Fuses
Fuses in passenger compartment A
If any electrical component does not
work, check the condition of the fuses.
Unclip the access flap A.
To comply with current legislation, or
as a
Battery
To avoid all risk of sparks:
Ensure that any electrical consumers
(courtesy lights, etc.) are switched
off before disconnecting or reconnecting
the battery.
When charging, stop the charger
Fitting a radio
Radio location 1
Unclip the blanking cover. The aerial, +
and – supply and speaker wire connections
are located behind it.
Door speakers 2
To install any equipment, please consult
an a
SEE MORE:
Electro-hydraulic unit: Removal - Refitting
K9K, and JA5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Note:
When replacing the electric pump assembly,
always replace the control relay.
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Disc
Injector holder shim: Removal - Refitting
K4J or K4M
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(80A, Battery).
K4M, and 862
Remove:
the air resonator (1).
the air filter unit air inlet pipe (2),
the dipstick,
the dipstick guide bolts (3).
Move aside the dipstick
