Adjustment of the front seats
Fig. 75 Front left seat controls
To fold and unfold the seat back*
(for two-door vehicles without the function Easy - Entry*)
– To fold the seat back down, pull the lever
upwards, in the direction of the arrow
and push the seat back forwards. – To unfold the seatback, push it back.
To fold and unfold the seat back*
(for two-door vehicles with the function Easy - Entry*)
– To fold the seat back down, pull the lever
upwards, in the direction of the arrow
and push the seat back forwards. You can push the seat forwards at the same time
to make entry to the rear seats easier. – To unfold the seat back, first move the
seat completely back.
Adjusting the seat forwards and
backwards
– Pull up the grip and move the seat forwards or backwards. – Then release the
grip
and move the seat
further until the catch engages.
Adjusting the seat height
– Pull the lever up or push down (several times if necessary) from its home position. This adjusts the seat height in stages.
Adjusting the backrest angle
– Take your weight off the backrest and turn the hand wheel.
The Easy-Entry function facilitates the access to the vehicle rear seats. Before lifting the seat back, return the seat to the original position. The seat inserts when the seat back is lifted.
WARNING
• Never adjust the driver or front passenger seat while the vehicle is in motion. While adjusting your seat, you will assume an incorrect sitting position. Risk of fatal accidents. Adjust the driver or front passenger seat only when the vehicle is stationary.
• To reduce the risk of injury to the driver and front passenger during sudden braking manoeuvres or an accident, never drive with the backrest tilted far to the rear. The maximum protection of the seat belt can be achieved only when the backrests are in an upright position and the driver and front passenger have properly adjusted their seat belts. The further the backrests are tilted to the rear, the greater the risk of injury due to improper positioning of the belt web!
• Exercise caution when adjusting the seat height or forwards/backwards position. Injuries can be caused if the backrest is tilted without due care and attention.
Heated seats
The front seat cushions and backrests can be heated electrically.
Fig. 76 Thumb wheel for the front seat heating
– Turn the appropriate thumb wheel, fig. 76 to switch on the seat heating. The seat heating is switched off in the 0 position.
The seat heating only works when the ignition is switched on. The left thumb wheel controls the left seat and the right thumb wheel the right seat.
Caution
To avoid damaging the heating elements, please do not kneel on the seat or apply sharp pressure at a single point to the seat cushion and backrest.
Nissan Micra. Warning lights
Anti-lock Braking System
(ABS) warning light
When the ignition switch is placed in the ON
position, the ABS warning light illuminates and
then turns off. This indicates the ABS is operational.
...
Fiat Punto. If an interior light burns out
For the type of bulb and power rating, see “When needing to change a
bulb”.
CEILING LIGHT
With toggling lens
To change the bulb, proceed as follows:
remove the ceiling light by releasing t ...
Honda Fit. Brake/Clutch Fluid
Specified fluid: Honda Heavy Duty Brake Fluid DOT 3
Use the same fluid for both the brakes and clutch.
NOTICE
Brake fluid marked DOT 5 is not compatible with your
vehicle’s braking system and ca ...