To engage the gears, press the clutch pedal fully and shift the gear lever into one of the required positions (the diagram is shown on the knob).
IMPORTANT The car can only be put into reverse gear when it has stopped moving completely. With the engine running, before engaging the reverse, wait at least 2 seconds with the clutch pedal fully down to prevent damage and grating of the gears.
To engage reverse (R) from neutral proceed as follows:
To change gears properly
you must push the clutch pedal fully down. It is therefore essential that there is nothing under the pedals: make sure mats are lying flat and do not get in the way of the pedals. |
Do not drive with your
hand resting on the gear lever as the force exerted, even if slight, could lead over time to premature wear on the gearbox internal components. |
Mazda 2. Automatic Transaxle Controls
Various Lockouts:
Indicates that you must depress
the brake pedal and hold in the lock-release
button to shift (The ignition must be switched ON).
Indicates the selector lever can
be shifte ...
Seat Ibiza. Fitting a towing bracket
It is possible to fit a towing bracket to the rear of the vehicle.
Fig. 123 Attachment points for towing bracket
If a towing bracket is to be fitted after the vehicle is purchased, this must
be ...
Peugeot 208. A few definitions
Range (miles or km)
This indicates the distance which can still be travelled with the fuel remaining
in the tank in relation to the average fuel consumption over the last few miles
(kilometres) ...