Unscrew cap and check that the fluid level in the reservoir is at maximum.
Fluid level in the reservoir shall not exceed the MAX mark.
If fluid has to be added, it is suggested to use the brake fluid in table “Fluids and lubricants” (see chapter “Technical specifications”). When opening cap take the utmost care to prevent impurities entering the tank.
For topping up, always use a funnel with integrated filter with mesh equal to or lower than 0.12 mm.
IMPORTANT Brake fluid absorbs moisture; for this reason, if the car is mainly used in areas with a high degree of atmospheric humidity, the fluid should be replaced at more frequent intervals than specified in the “Service schedule”.
Make sure that the
highly corrosive brake fluid does not drip onto the paintwork. If it does, wash it off immediately with water. |
Brake fluid is poisonous
and highly corrosive. In the event of accidental contact, wash the parts involved immediately with neutral soap and water, then rinse thoroughly. Call the doctor immediately if the fluid is swallowed. |
The symbol
on the container indicates synthetic brake fluid, distinguishing it from the mineral kind. Using mineral fluids irreversibly damages the special braking system rubber seals. |
Seat Ibiza. Petrol engine 1.4 litre 55 kW (75 hp). Automatic
General engine data
a) Research-Octane-Number = Measure of the predetonation power of the petrol.
b) Slight power loss
Performance figures
Weights
Trailer weights
Engine oil capacity
...
Peugeot 208. Locking / unlocking from the inside
Press the switch.
This allows the doors and the boot to be locked or unlocked.
If one of the doors is open, the doors are not locked.
When locking / deadlocking from outside
When the vehicle is ...
Nissan Micra. Checking lights
With all doors closed, apply the parking brake,
fasten the seat belts and place the ignition switch
in the ON position without starting the engine.
The following lights (if so equipped) will come ...