B-Class car manuals
Peugeot 208: Rear parking sensors - Parking sensors - Driving - Peugeot 208 Owners Manual

Peugeot 208: Rear parking sensors

Peugeot 208 Owners Manual

The system is switched on by engaging reverse gear. This is accompanied by an audible signal. The system is switched off when you exit reverse gear.


Audible assistance

The proximity information is given by an intermittent audible signal, the frequency of which increases as the vehicle approaches the obstacle. The sound emitted by the speaker (right or left) indicates the side on which the obstacle is located.

When the distance between the vehicle and the obstacle becomes less than approximately thirty centimetres, the audible signal becomes continuous.


Visual assistance

This supplements the audible signal by displaying bars in the multifunction screen which move progressively nearer to the vehicle. When the obstacle is near, the "Danger" symbol is also displayed in the screen.

Deactivation / Activation of the rear parking sensors


The function is deactivated by pressing this switch. The indicator lamp in the switch comes on.

Pressing this switch again reactivates the function. The indicator lamp in the switch goes off.

The function will be deactivated automatically if a trailer is being towed or a bicycle carrier is fitted (vehicle fitted with a towbar or bicycle carrier recommended by PEUGEOT).

    Parking sensors

    Operating fault

    Other info:

    Mazda 2. Engine Start Function When Key Battery is Dead
    CAUTION When starting the engine by holding the transmitter over the push button start due to a dead key battery or a malfunctioning key, be careful not to allow the following, otherwise t ...

    Renault Clio. Stop and Start Function
    This system enables a reduced fuel consumption and lower greenhouse gas emissions. The system is activated automatically when the vehicle is started. While driving, the system stops the engine (s ...

    Peugeot 208. Programming
    Turn thumb wheel 1 to the "CRUISE" position: the cruise control mode is selected but is not switched on (PAUSE). Set the programmed speed by accelerating to the required speed, then pre ...

    Manuals For Car Models


    © 2016-2024 Copyright www.b-auto.net 0.0089