The ignition must be switched ON to use the turn and lane-change signals.
Direction Indicators
Move the signal lever down (for a left turn) or up (for a right turn) to the stop position. The signal will self-cancel after the turn is completed.
If the indicator light continues to fl ash after a turn, manually return the lever to its original position.
The direction indicators (green) in the instrument cluster fl ash according to the operation of the direction indicator lever to show which signal is working.
NOTE
Lane-Change Signals
Move the lever halfway toward the direction of the lane change—until the indicator fl ashes— and hold it there. It will return to the off position when released.
Three-Flash Turn Signal
To signal a lane change, operate the direction indicator lever up or down slightly and release. After releasing the lever, the direction indicator fl ashes three times.
NOTE
The three-fl ash turn signal function can be switched to operable/inoperable using the personalisation function.
Refer to Personalisation Features on page 9-13 .
Fiat Punto. Parking
Proceed as follows:
Stop the engine and engage the handbrake;
Engage a gear (first if the car is faced uphill or
reverse if it is faced downhill) and leave the wheels
steered.
Block the w ...
Chevrolet Sonic. Rear Wiper Blade Replacement
1. Pull the wiper arm a short distance away from the glass (1).
2. Pull the blade out from the arm (2).
It may require extra effort to remove the old blade.
3. Once the blade pin disengages fro ...
Skoda Fabia. Preparations for using the breakdown kit
The following preparatory work must be carried out before using the breakdown
kit.
Park the vehicle as far away as possible from the flow of traffic. Park
on as
flat and firm a surface as po ...