1. Open the hood. See Hood.
2. For the driver side bulb, remove the windshield washer bottle filler neck by turning it one-quarter turn counterclockwise and pulling it straight up and out of the bottle.
3. Remove the headlamp bulb access cover.
4. Turn the bulb counterclockwise and pull straight back.
5. Disconnect the wiring harness connector from the bulb.
6. Install the new bulb in the headlamp assembly by turning clockwise.
7. Reconnect the wiring harness connector.
8. Install the headlamp bulb access cover.
9. For the driver side bulb, replace the windshield washer bottle filler neck by turning it one-quarter turn clockwise into the bottle.
Fiat Punto. General instructions
When a light is not working, check that the
corresponding fuse is intact before changing a bulb.
For the location of fuses, refer to the paragraph “If
a fuse blows” in this section;
Bef ...
Chevrolet Sonic. Washer Fluid
Open the cap with the washer symbol on it. Add washer fluid until the tank is
full. See Engine Compartment Overview for reservoir location.
Caution
. Do not use engine coolant (antifree ...
Peugeot 208. Locking / unlocking from the inside
Press the switch.
This allows the doors and the boot to be locked or unlocked.
If one of the doors is open, the doors are not locked.
When locking / deadlocking from outside
When the vehicle is ...