Mazda 2: Active Driving Display
Mazda2 Owners Manual

WARNING
Always adjust the display brightness and position with the vehicle
stopped:
Adjusting the display brightness and position while driving the vehicle is
dangerous as
doing so could distract your attention from the road ahead and lead to an
accident.
CAUTION
- Do not try to adjust the angle or open/close the active driving
display manually.
Fingerprints on the display will make it diffi cult to view and using
excessive force
when operating it could cause damage.
- Do not place objects in the vicinity of the active driving
display. The active driving
display may not operate or any interference with its operation could cause
damage.
- Do not place beverages near the active driving display. If
water or other liquids are
splashed on the active driving display, it could cause damage.
- Do not place objects above the active driving display screen or
apply stickers to the
combiner as they will cause interference.
- A sensor is integrated to control the display's luminosity. If
the optical receiver is
covered, the display's luminosity will lower making the display diffi cult
to view.
- Do not allow intense light to hit the optical receiver.
Otherwise, it could cause damage.
NOTE
- It may be diffi cult to view the display when wearing
sunglasses. Take off your
sunglasses or adjust the luminosity.
- If the battery has been removed and re-installed or the battery
voltage is low, the
adjusted position may deviate.
- The display may be diffi cult to view or temporarily affected by
weather conditions
such as rain, snow, light, and temperature
- If the audio system is removed, the active driving display
cannot be operated.
The active driving display indicates the following information:
- Lane Departure Warning System (LDWS) Operation Conditions and Warnings
Refer to Lane Departure Warning System (LDWS) on page 4-102
- Smart City Brake Support (SCBS) Operation Conditions
Refer to Smart City Brake Support (SCBS) on page 4-123 .
- Vehicle Speed Setting Using Cruise Control
Refer to Cruise Control on page 4-135 .
- Turn-by-Turn (TBT) (Direction and Distance) and Lane Guidance
- Vehicle Speed
Each setting/adjustment for the active driving display can be performed on
the centre
display (Type C/Type D audio).
- Select the
icon on the home
screen and display the Settings screen.
- Select the AD-Disp tab.
- Select the desired item and perform the setting/adjustment.
- Height : Active driving display position
- Brightness Control : Method for adjusting screen brightness
(Automatically/Manually)
- Calibration : Brightness initialization setting (when selecting
automatic adjustment)
- Brightness : Brightness adjustment (when selecting manual adjustment)
- Navigation : On/Off
- Active Driving Display : On/Off
- Reset
Other info:
Nissan Micra. Fog lights (if so equipped)
If replacement is required, see a NISSAN dealer.
CAUTION
High pressure halogen gas is sealed
inside the halogen bulb. The bulb may
break if the glass envelope is scratched
or t ...
Peugeot 208. Removing a wheel
Parking the vehicle
Immobilise the vehicle where it does not block traffic: the ground must be level,
stable and not slippery.
Apply the parking brake, switch off the ignition and engage first gea ...
Mazda 2. Interior Lights
Overhead Lights
Front
Rear *
NOTE
(With map lights)
The rear overhead light also turn on and
off when the front overhead light switch
is operated.
Map Lights *
When the overhead light ...