Nissan Micra: Drive belt
Nissan Micra Owners Manual
HR16DE engine
- Water pump pulley
- Generator pulley
- Crankshaft pulley
- Air conditioner compressor pulley (if so equipped) /Idler pulley (if so equipped)
- Manual tensioner pulley
Tension checking point
| WARNING Be sure the ignition switch is placed in the OFF or LOCK position before servicing drive belt. The engine could rotate unexpectedly. |
- Visually inspect the belt for signs of unusual wear, cuts, or fraying. If the belt is in poor condition, have it replaced or adjusted by a NISSAN dealer.
- Have the belt checked regularly for condition.
Other info:
Nissan Micra. Uniform tire quality grading
DOT (Department of Transportation) Quality
Grades: All passenger car tires must conform to
federal safety requirements in addition to these
grades.
Quality grades can be found where applicable o ...
Peugeot 208. Battery
Procedure for charging your battery when it is flat or for starting the engine
using another battery.
The presence of this label indicates the use of a 12 V lead-acid battery with
special techn ...
Chevrolet Sonic. Personalization Menu (Radio with Touchscreen)
Settings can be made with the ignition ON and the vehicle not moving.
Use the audio system controls to access the personalization menus for customizing
vehicle features.
The following are all poss ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia - Honda Pilot
- Volkswagen ID4
- Toyota Prius
