The following procedures will help you get started using the Bluetooth® Hands-Free Phone System.
Choosing a language
To change the language, perform the following.
To select the current language, press the PHONE/SEND ( ) button. To select a different language, push the tuning switch ( or ) left or right.
NOTE: You must press the button within 5 seconds to change the language.
Connecting procedure
NOTE: The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled.
The connecting procedure of the cellular phone varies according to each cellular phone model. Refer to the cellular phone Owner’s Manual for details.
When prompted for a Passkey code, enter “1234” from the handset. The Passkey code “1234” has been assigned by NISSAN and cannot be changed.
Making a call by entering a phone number
Say: “Special Number” to dial more than 10 digits or any special characters.
For additional information, refer to “List of commands” in this section.
Receiving a call
When you hear the ring tone, press the
button on the steering wheel.
Once the call has ended, press the
button
on the steering wheel.
NOTE:
If you do not wish to take the call when you
hear the ring tone, press the
button
on the steering wheel.
For additional information, refer to “List of commands” in this section.
Ford Fiesta. Steering Wheel
Adjusting the Steering Wheel
WARNING
Do not adjust the steering wheel
when your vehicle is moving.
Note: Make sure that you are sitting in the
correct position. See Sitting in the Correct
Position.
...
Mazda 2. Message Indicated on Display
If a message is displayed in the centre display (Type C/Type D audio), take
appropriate
action (in a calm manner) according to the displayed message.
Stop Vehicle in Safe Place Immediately
If ...
Chevrolet Sonic. Immobilizer Operation
This vehicle has a passive theft-deterrent system.
The system does not have to be manually armed or disarmed.
The vehicle is automatically immobilized when the key is removed from the ignition.
The ...