
Temporarily keeping the dipped beam headlamps on after the vehicle's ignition has been switched off makes the driver's exit easier when the light is poor.

Switching on
With the ignition off, "flash" the headlamps using the lighting stalk.
A further "headlamp flash" switches the function off.

Manual guide-me-home lighting is also available from the remote control lighting button (see "Access - Remote control").
Switching off
The manual guide-me-home lighting switches off automatically after a set time.
Mazda 2. Changing a Flat Tyre (With Spare Tyre)
NOTE
If the following occurs while driving, it
could indicate a fl at tyre.
Steering becomes diffi cult.
The vehicle begins to vibrate
excessively.
The vehicle pulls in one direction.
I ...
Renault Clio. Seat belts
Always wear your seat belt when travelling
in your vehicle. You must also
comply with the legislation of the particular
country you are in.
Make sure that the rear bench seat
is locked i ...
Mazda 2. Turning the Engine Off
WARNING
Do not stop the engine while the
vehicle is moving:
Stopping the engine while the vehicle is
moving for any reason other than in an
emergency is dangerous. Stopping the
engine while the ...