
Brake servo
The brake servo amplifies the pressure you apply to the brake pedal. It works only when the engine is running. If the brake servo is not functioning due to a malfunction, or if the vehicle has to be towed, you will have to press the brake pedal considerably harder to make up for the lack of servo assistance.
WARNING
The braking distance can also be affected by external factors.
• Never let the vehicle coast with the engine switched off. Failure to do so could result in an accident. The braking distance is increased considerably as the brake servo does not function.
• If the brake servo is not functioning, for example if the vehicle is being towed, you will have to press the brake pedal considerably harder than normal.
Brake assist system (BAS)
The Brake Assist System function is only included in vehicles with ESP. In an emergency, most drivers brake in time, but not with maximum force. This results in unnecessarily long braking distances. The brake assist system intervenes here, if you press the brake pedal very quickly, the brake assist system registers an emergency situation. It then very quickly builds up the full brake pressure so that the ABS can be activated more quickly and efficiently, thus reducing the braking distance. Do not reduce the pressure on the brake pedal. The brake assist system switches off automatically as soon as you release the brake.
WARNING
• The risk of accident is higher if you drive too fast, if you do not keep your distance to the vehicle in front, and when the road surface is slippery or wet. The increased accident risk cannot be reduced by the brake assist system.
• The brake assist system cannot defy the laws of physics. Slippery and wet roads are dangerous even with the brake assist system! Therefore, it is essential that you adjust your speed to suit the road and traffic conditions. Do not let the extra safety features tempt you into taking any risks when driving.
Renault Clio. Five door and estate versions
Reversing lights and rear fog
lights 12
Open the boot lid.
Unclip cover 13 and remove it.
Turn bulb holder 14 fully anticlockwise
and change the bulb.
To reassemble, proceed in the ...
Fiat Punto. Failure warning lights
Any failure is indicated by cluster warning light
coming on together with the message on the
reconfigurable multifunction display (where required)
(see section “Warning lights and messages”). ...
Peugeot 208. Stop & Start
Going into engine STOP mode
The "ECO" warning lamp
comes on in the instrument panel and the engine goes into standby:
- with a manual gearbox , at speeds below 12 mph (20 km/h), when you ...