B-Class car manuals
Chevrolet Sonic: Daytime Running Lamps (DRL) - Exterior Lighting - Lighting - Chevrolet Sonic Owners Manual

Chevrolet Sonic: Daytime Running Lamps (DRL)

Chevrolet Sonic Owners Manual

DRL can make it easier for others to see the front of your vehicle during the day. Fully functional DRL are required on all vehicles first sold in Canada.


This indicator light turns on in the instrument cluster when the DRL are on.

A light sensor on top of the instrument panel makes the DRL work, so be sure it is not covered.

The DRL system makes the low-beam headlamps come on at a reduced brightness when the following conditions are met:

  • The ignition is in the ON/ RUN mode.
  • The exterior lamp control is in AUTO.
  • The engine is running.

When the DRL are on, only the low-beam headlamps, at a reduced level of brightness, will be on. The taillamps, sidemarker, instrument panel, and other lamps will not be on.

The headlamps automatically change from DRL to the regular headlamps depending on the darkness of the surroundings. The other lamps that come on with the headlamps will also come on.

When it is bright enough outside, the headlamps go off and the DRL come on.

To turn the DRL lamps off or on again, turn the exterior lamp control to and then release. For vehicles first
sold in Canada, the DRL lamps cannot be turned off.

    Flash-to-Pass

    Automatic Headlamp System

    Other info:

    Chevrolet Sonic. Safety Belt Pretensioners
    This vehicle has safety belt pretensioners for front outboard occupants. Although the safety belt pretensioners cannot be seen, they are part of the safety belt assembly. They can help tighten the ...

    Peugeot 208. Identifi cation markings
    Various visible markings for the identification of your vehicle. A. Vehicle Identification Number (VIN) under the bonnet. This number is engraved on the bodywork near the damper support. B. Vehi ...

    Peugeot 208. Programming
    Turn thumb wheel 1 to the "CRUISE" position: the cruise control mode is selected but is not switched on (PAUSE). Set the programmed speed by accelerating to the required speed, then pre ...

    Manuals For Car Models


    © 2016-2025 Copyright www.b-auto.net 0.0081