B-Class car manuals
Mazda 2: Head Restraints - Seats - Essential Safety Equipment - Mazda2 Owners Manual

Mazda 2: Head Restraints

Mazda2 Owners Manual

Your vehicle is equipped with head restraints on front seats, rear outboard seats* and the rear centre seat * . The head restraints are intended to help protect you and the passengers from neck injury.

WARNING

Always drive with the head restraints installed when seats are being used and make sure they are properly adjusted.

In addition, always raise the head restraints mentioned below when they are being used: Driving with the head restraints adjusted too low or removed is dangerous. With no support behind your head, your neck could be seriously injured in a collision.

(Head restraints which must be raised for use)

  • All rear seat head restraints

Height Adjustment

Adjust the head restraint so that the centre is even with the top of the passenger's ears.

Height Adjustment


To raise a head restraint, pull it up to the desired position.

To lower the head restraint, press the stopcatch release, then push the head restraint down.

Front outboard seat

Front outboard seat


Rear outboard seat *

Rear outboard seat


Rear centre seat *

Rear centre seat


Removal/Installation

To remove the head restraint, pull it up while pressing the stop-catch.

To install the head restraint, insert the legs into the holes while pressing the stopcatch.

WARNING

Always drive with the head restraints installed when seats are being used and make sure they are properly installed: Driving with the head restraints not installed is dangerous. With no support behind your head, your neck could be seriously injured in a collision.

After installing a head restraint, try lifting it to make sure that it does not pull out: Driving with an unsecured head restraint is dangerous as the effectiveness of the head restraint will be compromised which could cause it to unexpectedly detach from the seat.

CAUTION

  • When installing a head restraint, make sure that it is installed correctly with the front of the head restraint facing forward. If the head restraint is installed incorrectly, it could detach from the seat during a collision and result in injury.
  • The head restraints on each of the front and rear seats are specialized to each seat. Do not switch around the head restraint positions. If a head restraint is not installed to its correct seat position, the effectiveness of the head restraint during a collision will be compromised which could cause injury.
    Rear Seat

    Seat Belt Systems

    Other info:

    Nissan Micra. Vehicle Dynamic Control (VDC) off switch
    The vehicle should be driven with the VDC system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The en ...

    Mazda 2. Owner Maintenance Precautions
    Routine Service We highly recommend that these items be inspected daily, or at least every week. Engine Oil Level (page 6-28 )  Engine Coolant Level (page 6-29 ) Brake and clutch Fluid ...

    Nissan Micra. Switch operation
    Type A (if so equipped) The windshield wiper and washer operates when the ignition switch is in the ON position. Push the lever down to operate the wiper at the following speed: Intermit ...

    Manuals For Car Models


    © 2016-2026 Copyright www.b-auto.net 0.2702