Peugeot 208: 1.6 litre HDi engine
Peugeot 208 Owners Manual
- Fill the fuel tank with at least five litres of diesel.
- Open the bonnet.
- If necessary, unclip the styling cover for access to the priming pump.
- Squeeze and release the priming pump repeatedly until resistance is felt (there may be resistance at the first press).
- Operate the starter until the engine starts (if the engine does not start at the first attempt, wait around 15 seconds before trying again).
- If the engine does not start after a few attempts, operate the priming pump again then start the engine.
- Clip the styling cover back in place.
- Close the bonnet.
Other info:
Peugeot 208. Direction indicators
Lower the lighting control stalk fully when moving to the left.
Raise the lighting control stalk fully when moving to the right.
If you forget to cancel the direction indicators for more tha ...
Honda Fit. VSA® (Vehicle Stability Assist), aka ESC (Electronic Stability Control),
System
VSA® helps to stabilize the vehicle during cornering if the vehicle turns
more or less
than what was intended. It also assists in maintaining traction on slippery
surfaces.
It does so by regu ...
Honda Fit. Automatic Transmission
■Creeping
The engine may run at a higher idle speed and creeping increases:
• Immediately after the engine starts.
• When the heating and cooling system is in use.
Keep the brake pedal f ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia - Honda Pilot
- Volkswagen ID4
- Toyota Prius
