Peugeot 208: Access to the spare wheel
Peugeot 208 Owners Manual
The spare wheel is installed in the boot under the floor.
According to country, the spare wheel may be steel, alloy or of the "space-saver" type. To gain access to it, refer to the paragraph "Access to the tools" on the previous page.
Taking out the wheel
- Unscrew the yellow central bolt.
- Raise the spare wheel towards you from the rear.
- Take the wheel out of the boot.
Putting the wheel back in place
- Put the wheel back in its housing.
- Unscrew the yellow central bolt by a few turns then put it in place in the centre of the wheel.
- Tighten fully until the central bolt clicks to retain the wheel correctly.
Put the box back in the centre of the wheel and clip it in place.
Other info:
Seat Ibiza. Wheels
General notes
Avoiding damage
– If you have to drive over a kerb or similar obstacle, drive very slowly and
as near as possible at a right angle to the kerb. – Keep grease, oil and fuel off
...
Mazda 2. If a Warning Light Turns On or Flashes
If any warning light turns on/fl ashes, take appropriate action for each
light. There is no
problem if the light turns off, however if the light does not turn off or turns
on/fl ashes again,
con ...
Ford Fiesta. Stability Control
Principle of Operation
Electronic Stability Program
WARNINGS
The system does not relieve you of
your responsibility to drive with due
care and attention. Failure to drive
with due care and attention c ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia - Honda Pilot
- Volkswagen ID4
- Toyota Prius
