Application
Pull the parking brake lever up to immobilise your vehicle.
Release
Pull the parking brake lever up gently, press the release button then lower the lever fully.
When the vehicle is
being driven, if this warning lamp and the STOP warning lamp come on, accompanied
by an audible signal and a message in the screen, indicating that the parking brake
is still on or has not been fully released.
When parking on a slope, direct your wheels against the kerb, apply the parking brake, engage a gear and switch off the ignition.
Honda Fit. Fastening a Seat Belt
After adjusting a front seat to the proper position, and while sitting
upright and well
back in the seat:
1. Pull the seat belt out slowly.
2. Insert the latch plate into the buckle, then
tu ...
Nissan Micra. Tachometer
The tachometer indicates engine speed in revolutions
per minute (rpm). Do not rev the engine
into the red zone 1 .
CAUTION
When engine speed approaches the red
zone, shift to a hig ...
Fiat Punto. Parking sensors
The parking system detects and informs the driver (through an
intermittent acoustic signal) about the presence of obstacles in the rear
part of the car.
ACTIVATION
The sensors are automaticall ...